![]() Reference to the procedures and the metrological chain used in the calibration process.Environmental conditions during the calibration process.Calibration uncertainty expressed as extended uncertainty of the calibration coefficients resulting from the tests performed.Calibration coefficients and average calibration coefficient for calibration tests performed. ![]() Flow rate measured by the Mass Flow Meter under standard conditions of 0 ° C and 101325 Pa.Primary flow rate at standard reference conditions of 0 ☌ and 101325 Pa.We perform the calibration of Mass Flow Meter (MFM) from 3 to 10 calibration points between 5/10% and 100% of the measuring range of the device under test (DUT) with a minimum of 3 repetitions of the calibration test, up to 5 repetitions of the calibration test.Īs result of the performed test, a calibration report will be issued containing: The Mass Flow Meter (MFM) calibration is performed by comparing the sample flow measurement with our primary standard flow rate, according to the calibration method defined in the calibration procedures stored at our calibration laboratory. The Mass Flow Meter (MFM) calibration takes place in our laboratory under controlled temperature and humidity conditions, in the following ranges: As Found Data (initial calibration of meter in the received condition) As Left Data (if meter is out of tolerance, the meter will be adjusted to pass) Additional calibration requirements. The flow rates indicated are expressed in reference to temperature and pressure standard conditions: 0 ° C and 101325 Pa. Standard Commercial Grade NIST Traceable. The calibrations can be carried out with the following anhydrous gases: air and nitrogen. At our calibration facility we carry out Mass Flow Meters (MFMs) in the range of 5,0 Sml / min - 50,0 Sl/min.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |